Edition - Novell OPEN WORKGROUP SUITE SMALL BUSINESS EDITION 9.3 - INSTALLATION AND ADMINISTRATION GUIDE 10-2007 Administration Manual

8 Run the following command: /opt/simba/modules/sbs/bin/copyMedia.sh.
9 Reboot the server and continue with
2.1.2 Using the NOWS SBE DVD to Install the Novell Open
Workgroup Suite Small Business Edition
1 Insert the NOWS SBE DVD into the DVD drive.
2 After installation, your computer will reboot. When it boots up, perform the following steps
3 Boot the server. You will be presented with the a splash screen, and then the installation screen.
4 The server starts the installation process, then stops at the installation summary screen. To
5 Click Accept to continue with the installation.
6 When the base installation of the server completes, enter the IP address that is presented on the
7 (Conditional) If you receive an IP address of https://127.0.0.1:8181, or https://:8181 instead of
8 The first page you are presented with is the End User License Agreement (EULA). Read
9 Enter the host name for your server and verify the remaining network information. The IP
18 Novell Open Workgroup Suite Small Business Edition 9.3 Administration and Installation Guide
drwxr-xr-x 8 root root
drwxr-xr-x 4 root root
drwxr-xr-x 2 root root
drwxr-xr-x 2 root root 75048 Aug 30 07:04 i586
drwxr-xr-x 2 root root
drwxr-xr-x 2 root root 13072 Aug 30 2007 noarch
drwxr-xr-x 2 root root
drwxr-xr-x 3 root root
before doing any further configuration or component installation.
Click Installation.
NOTE: Do not change the software packages or configurations in YaST. Doing so causes your
installation to fail.
accept system defaults, click Accept; otherwise, click Change to modify settings.
The installation copies the files required to install the SUSE Linux Enterprise server and related
service packs. You are also presented with a status screen so you can monitor the time
remaining on the installation.You have approximately 20 minutes before the next intervention
is necessary.
screen. The rest of the server configuration is Web-browser-based.
a valid IP address, complete the following steps to fix the problem:
7a Verify that you are connected to the network with your DHCP server.
7b At the command line, log in as root without a password.
The rest of the installation process is completed from a Web browser. Refer to
"Requirements," on page 13
7c Enter the following command: /etc/init.d/network restart.
through the agreement and click I Agree to advance to the next page.
The next page is where you set up the network settings for your NOWS SBE server.
address, netmask, gateway, and DNS address should be those provided by your DHCP server.
Verify that this is accurate. The netmask and gateway can be changed to match that of your
192 Aug 30 07:08
96 Aug 30 06:53
3384 Aug 30 2007 i386
752 Aug 30 2007 i686
344 Aug 30 2007 nosrc
120 Aug 30 2007 setup
Step 3 on page 18.
for information on supported browsers.
Section 1.3,