Installing Dhcp Advanced - Novell OPEN WORKGROUP SUITE SMALL BUSINESS EDITION 9.3 - INSTALLATION AND ADMINISTRATION GUIDE 10-2007 Administration Manual

4 Review the settings. To make a change, click Back. To proceed with the installation, click
5 The DCHP basic installation is now complete. Click Finish to return to the available software

18.2 Installing DHCP Advanced

1 Click Install under Available Components.
2 Click Advanced, then click Next.
3 Specify your DHCP configuration.
96 Novell Open Workgroup Suite Small Business Edition 9.3 Administration and Installation Guide
Next.
page.
DHCP Settings: Verify that the DHCP settings are correct for your network.
Subnet: Specify the network's subnet IP address.
Netmask: Specify the network's subnet mask.
IP Range Start: Specify beginning number of the range of your network's IP addresses (0
is usually the network address).
IP Range End: Specify the ending number of the range of your network's IP addresses
(255 is usually the broadcast address).
DNS 1: Specify the IP addresses of your DNS server.
DNS 2: Specify the IP address of an alternative DNS server.
Default Route: Specify the default route for DHCP clients. This is the IP address of the
next hop router that the clients would go for any traffic off their network. If your server is
the NAT/internal gateway, use the server's internal IP address for this setting.
Domain: This is your company's domain name.