Vpn Site-To-Site; Installing Two Nics; Section 14.4, "Vpn Site-To-Site - Novell OPEN WORKGROUP SUITE SMALL BUSINESS EDITION 9.3 - INSTALLATION AND ADMINISTRATION GUIDE 10-2007 Administration Manual

10 After the installation completes, a new program is visible in the taskbar. Click the new icon to

14.4 VPN Site-to-Site

14.4.1 Installing Two NICs

It is best to complete the installation and configuration of the first network interface card (NIC)
through the Web configuration tool before configuring a second NIC. After the initial Web
configuration is complete, you can then use YaST to configure the second NIC.
80 Novell Open Workgroup Suite Small Business Edition 9.3 Administration and Installation Guide
launch OpenVPN with the new configuration, and a status window displays, showing the
connection progress:
When the connection is fully established, the status window disappears and the taskbar briefly
shows the new VPN address. At this point, the VPN tunnel has been established and OpenVPN
has been successfully downloaded.
The VPN tunnel can be broken by right-clicking in the taskbar icon and selecting disconnect.
Section 14.4.1, "Installing Two NICs," on page 80
Section 14.4.2, "VPN Site-to-Site Setup," on page 81
Section 14.4.3, "Troubleshooting Tips," on page 82