Connecting; Related Information; Connecting The Ethernet Ports - Cisco 1240 Hardware Installation Manual

Chapter 6 Installing the Router
•

Connecting

You can connect SFP modules to these ports while the router is operating normally. The SFP ports are
labeled ETH 1/2 and ETH 2/2.
When installing or removing SFP modules, observe these guidelines:
•
•
This section describes how to install SFP modules. SFP modules are inserted into the SFP ports shown
in Figure
Step 1 Attach an ESD-preventive wrist strap to your wrist and to a bare metal surface.
Step 2 For fiber-optic SFP modules, remove the dust plugs and store them in a clean location for reuse.
Position the SFP transceiver module in front of the socket opening, and insert the SFP into the socket
Step 3
until you feel the connector latch into place.
Step 4 Remove the dust plugs from the network interface cable LC connectors.
Step 5 Inspect and clean the LC connector's fiber-optic end-faces.
Thread the SFP cable through the chassis cable ports that are reserved for the SFP cables
Step 6
You must use cable glands with the chassis cable ports on the router. See the
Note
Chassis Cable Ports" section on page
Step 7 Attach the network interface cable connector to the SFP transceiver module.

Related Information

•
•

Connecting the Ethernet Ports

See
OL-26223-04
Fiber-optic end-face cleaning tools and inspection equipment. For complete information on
inspecting and cleaning fiber-optic connections, see the white-paper document at this URL:
http://www.cisco.com/en/US/tech/tk482/tk876/technologies_white_paper09186a0080254eba.shtm
l
Removing and installing an SFP module can shorten its useful life. Do not remove and insert any
module more often than is absolutely necessary.
To prevent ESD damage, follow your normal board and component handling procedures when
connecting cables to the switch and other devices.
3-21.
For supported SFP modules, see the
For detailed information on connecting the SFP module cable to the network, see Cisco.com for the
documentation for your SFP module.
Figure 3-15 for Ethernet port locations.
6-12.
"Router Hardware Description"
Cisco 1240 Connected Grid Router Hardware Installation Guide
Additional Router Connections
(Figure 6-7).
"External Connections and
chapter.
6-21