Bale Clasp Sfp Or Sfp+ Module; Install A Bale Clasp Sfp Or Sfp+ Module - Cisco NCS 540 Hardware Installation Manual

Hide thumbs Also See for NCS 540:

Table of Contents

Install the Device

Note

When installing an SFP or SFP+ module, you should hear a click as the triangular pin on the bottom of the

module snaps into the hole in the receptacle. The click indicates that the module is correctly seated and secured

in the receptacle. Verify that the modules are completely seated and secured in their assigned receptacles on

the line card by firmly pushing on each SFP or SFP+ module.

Bale Clasp SFP or SFP+ Module

The bale clasp SFP or SFP+ module has a clasp that you use to remove or install the module (see the figure

below).

Figure 13: Bale Clasp SFP or SFP+ Module

To install this type of SFP or SFP+ module, follow these steps:

Step 1

Attach an ESD-preventive wrist or ankle strap and follow its instructions for use.

Step 2

Close the bale clasp before inserting the SFP module.

Step 3

Line up the SFP module with the port and slide it into the port (see the figure below).

Figure 14: Installing a Bale Clasp SFP Module into a Port

Note

When installing an SFP or SFP+ module, you should hear a click as the triangular pin on the bottom of the SFP

module snaps into the hole in the receptacle. This click indicates that the module is correctly seated and secured

in the receptacle. Verify that the SFP modules are completely seated and secured in their assigned receptacles

on the line card by firmly pushing on each SFP module.

Bale Clasp SFP or SFP+ Module

Cisco NCS 540 Router Hardware Installation Guide

Table of Contents

Show Quick Links

Table of Contents