1-Port Channelized Stm-1/Oc-3 Spa Cables And Connectors; Figure 2-16 Sfp Optics Module - Cisco 12000 - Series Chassis Modular Expansion Base Hardware Installation Manual

Router sip and spa
Hide thumbs Also See for 12000 - Series Chassis Modular Expansion Base:
Table of Contents

Advertisement

Chapter 2
Overview: Cisco 12000 Series Router Shared Port Adapters
The 1-Port Channelized STM-1/OC-3 SPA interface is compliant with RFC 1619, PPP over
SONET/SDH, and RFC 1662, PPP in HDLC-like Framing. The 1-Port Channelized STM-1/OC-3 SPA
also provides support for SNMP v1 agent (RFC 1155–1157), and Management Information Base (MIB)
II (RFC 1213).

1-Port Channelized STM-1/OC-3 SPA Cables and Connectors

The 1-Port Channelized STM-1/OC-3 SPA uses a small form-factor pluggable (SFP) optical transceiver
module installed in each port for SONET and SDH single-mode and multimode optical fiber connection
(see

Figure 2-16 SFP Optics Module

The SFP optical transceiver modules used with the 1-Port Channelized STM-1/OC-3 SPA provide the
following optical fiber options:
For single-mode and multimode optical fiber connections, you can use either a duplex LC-type cable (see
Figure
Use single-mode (for intermediate- or long-reach configurations) or multimode optical fiber cable to
connect your router to a network or to connect two 1-Port Channelized STM-1/OC-3 SPA-equipped
routers back to back.
Long-range SFP optical transceiver modules (for long-reach configurations) cannot be connected
back-to-back without using an attenuator between the two of them.
Release 12.0(32)SY1, OL-8831-01, Rev. G6, July 19, 2007
Figure
2-16).
Multimode—155-Mbps, OC-3c/STM-1 optical fiber (SONET STS-3c or SDH STM-1)
Use a multimode optical fiber that has a core/cladding diameter of 62.5/125 microns.
Single-mode—155-Mbps, OC-3c/STM-1 optical fiber (SONET STS-3c or SDH STM-1)
Use a single-mode optical fiber that has a modal-field diameter of 8.7 ±0.5 microns. (Nominal
diameter is approximately 10/125 microns.)
2-17) or two simplex LC-type cables, one for transmit (TX) and one for receive (RX).
Cisco 12000 Series Router SIP and SPA Hardware Installation Guide
1-Port Channelized STM-1/OC-3 SPA Overview
2-29

Advertisement

Table of Contents
loading

This manual is also suitable for:

Gsr12/60-rf - 12012 router

Table of Contents