Figure 1-18 Cisco 12000 Sip-601 Face Plate; Table 1-16 Cisco 12000 Sip-601 Leds; Table 1-17 Cisco 12000 Sip-601 Physical Specifications - Cisco 12000 - Series Chassis Modular Expansion Base Hardware Installation Manual

Chapter 1 Overview: Cisco 12000 Series Router SPA Interface Processors
The interconnect between a SIP and a SPA can operate at either 2.5Gbps or 10Gbps. If the maximum
capacity of a SPA is greater than 2.5Gbps the interconnect operates at 10Gbps and the SPA is a "full-rate"
SPA. If the maximum capacity of a SPA is 2.5Gbps or less the interconnect operates at 2.5Gbps and the
SPA is a "quarter-rate" SPA. The Cisco 12000 SIP-601 can support up to two full-rate SPAs, or one
full-rate and three quarter-rate SPAs or four quarter-rate SPAs.
The Cisco 12000 SIP-601 face plate has one Status LED.
face plate with 2 single-width, single-height SPAs.

Figure 1-18 Cisco 12000 SIP-601 Face Plate

1
2
3
4
The Cisco 12000 SIP-601 LEDs are described in

Table 1-16 Cisco 12000 SIP-601 LEDs

LED Label
Status
Rate
Cisco 12000 SIP-601 Physical Specifications
The Cisco 12000 SIP-601 physical specifications are shown in the following table.

Table 1-17 Cisco 12000 SIP-601 Physical Specifications

Description
Physical dimensions
Shipping weight
Operating temperature
Release 12.0(32)SY1, OL-8831-01, Rev. G6, July 19, 2007
1
0
2
5 3
SPA subslot 0
SPA subslot 1
SPA subslot 2
SPA subslot 3
Color
Yellow
Green
Off
Green
Figure 1-18
5 Ejector Levers
6 Status LED
7
Rate LED
Table 1-16.
State Meaning
On SIP is powered and IOS is loading.
On SIP is active.
Off SIP is SIP-401 or SIP-501.
On SIP is SIP-601.
Specifications
Occupies one line card slot on a Cisco 12000 Series Router
10kg
32 to 104°F (0 to 40°C)
Cisco 12000 Series Router SIP and SPA Hardware Installation Guide
Cisco 12000 SIP-601 Overview
shows the Cisco 12000 SIP-601
6 2
3
7 4
1-19
1
5