Port 10 Gigabit Ethernet Modular Port Adapter - Cisco ASR 9901 Hardware Installation Manual

4-Port 10 Gigabit Ethernet Modular Port Adapter

Table 9: 20-Port Gigabit Ethernet Modular Port Adapter LEDs
LED Label
A/L
STATUS
4-Port 10 Gigabit Ethernet Modular Port Adapter
The 4-Port 10 Gigabit Ethernet modular port adapter provides four cages for XFP Ethernet optical interface
modules that operate at a rate of 10 Gbps. The four XFP modules can be 10-Gigabit Ethernet multimode or
single mode connections.
Each XFP cage on the 4-Port 10 Gigabit Ethernet modular port adapter has an adjacent Link LED visible on
the front panel. The Link LED indicates the status of the associated XFP port, as described in
on page 122
The following figure shows an example of the 4-Port 10 Gigabit Ethernet modular port adapter.
Figure 84: 4-Port 10 Gigabit Ethernet Modular Port Adapter
The following table describes the 4-Port 10 Gigabit Ethernet modular port adapter LEDs.
Cisco ASR 9901, ASR 9001, and ASR 9001-S Routers Hardware Installation Guide
76
Color State Meaning
Off Off Port is not enabled.
Green On Port is enabled and the link is up. The MPA A/L LED will blink green when there
is traffic activity.
Amber On Port is enabled and the link is down.
Off Off Modular port adapter power is off.
Green On Modular port adapter is ready and operational.
Amber On Modular port adapter power is on and good, and modular port adapter is being
configured.
section.
Installing Modules and Cables in the Chassis
Status LEDs,