1-Port Oc-192C/Stm-64 Pos/Rpr Xfp Spa Leds; Figure 2-24 1-Port Oc-192C/Stm-64 Pos/Rpr Xfp Spa Faceplate; Table 2-28 1-Port Oc-192C/Stm-64 Pos/Rpr Xfp Spa Leds - Cisco 12000 - Series Chassis Modular Expansion Base Hardware Installation Manual

1-Port OC-192c/STM-64 POS RPR XFP SPA Overview

1-Port OC-192c/STM-64 POS/RPR XFP SPA LEDs

The 1-Port OC-192c/STM-64 POS/RPR XFP SPA has six LEDs, as shown in

Figure 2-24 1-Port OC-192c/STM-64 POS/RPR XFP SPA Faceplate

1
2
3
The WRAP, PASSTHRU, and MATESYNC LEDs apply to the SPA in RPR/SRP mode only. As of
Note
Cisco IOS Release 12.0(31)S, RPR/SRP mode is not supported.
Table 2-28

Table 2-28 1-Port OC-192c/STM-64 POS/RPR XFP SPA LEDs

LED Label
WRAP
PASSTHRU
MATESYNC
CARRIER
Cisco 12000 Series Router SIP and SPA Hardware Installation Guide
2-38
1 3
2
WRAP LED
PASSTHRU LED
MATESYNC LED
describes the 1-Port OC-192c/STM-64 POS/RPR XFP SPA LEDs.
Color State
Off Off
Green On
Amber On
Off Off
Amber On
Off Off
Green On
Off Off
Green On
Amber On
Blinking SRP mode mismatch alarm is indicated.
Chapter 2 Overview: Cisco 12000 Series Router Shared Port Adapters
4
5
4
CARRIER LED
5 ACTIVE LED
6 STATUS LED
Meaning
Port is not in wrap mode.
Port is in wrap mode somewhere on the ring.
Port is in wrap mode locally.
Port is not in pass-thru mode.
Port is in pass-thru mode.
Mate port is not synchronized.
Mate port is synchronized.
Port is not enabled by software.
Port is enabled by software, and there is a valid SONET signal
without alarms.
Port is enabled by software, and there is at least one alarm (LOS,
LOF, RDI, and so on).
Release 12.0(32)SY1, OL-8831-01, Rev. G6, July 19, 2007
Figure 2-24.
SPA-0C192POS-XFP
6