JRC RADAR 1800 Instruction Manual page 53

N 4 2 ° 3 4 . 2 5 5 ' C O G 9 2 . 5 °
W 1 2 2 ° 1 9 . 4 8 7 ' S O G 2 5 . 5 K T S
°
H D G 82 . 5 S O G
T
°
C O G 92 . 5 S T W
T
°
B R G 72 . 5 D P T
T
W P T R N G
001 ABCDEFGH
E T A
21 OCT 10:54AM
X T E
0.02
V E S S E L P O S I T I O N
21 OCT
4 2 ° 5 1 . 8 1 8 '
N
8 7 ° 5 1 . 1 3 6 '
W
OFF COURSE SHALLOW
S O F T S O F T S O F T
K E Y K E Y K E Y
52
[Numeric Data]
DPT : Depth
SOG : Speed (Over Ground) (unit: KTS=knots, KPH=km/hour,
WPT: Waypoint ID
COG:Vessel course over ground (unit: degree/ T=true,
BRG : Bearing to destination (unit: degree/ T=true, M=magnetic)
RNG: Distance to destination (unit:0.1 NM)
XTE : Cross track error. Deviation from course and direction to
Steering required to return to the planned course is indicated
t (Left) and s (Right)
Notes:
• To display the vessel heading marker and HDG (Vessel heading), it is
necessary to receive the vessel heading data in the NMEA0183 standard
format. You need to connect the specified signal line to the NMEA
connector or DC12V/ COMPASS connector on the rear panel to receive
the vessel heading data.
• To display the water depth data, it is necessary to receive the depth data in
the NMEA0183 standard format. You need to connect the specified signal
line to the NMEA connector on the rear panel to receive the water depth
data.
NUM DATA Mode
Select NUM DATA to display the numeric display. The numeric
D G P S
25 . 5 display includes the numerical data of various navigation information
K T S
such as water depth, vessel speed, course, heading direction, deviation
20 . 3
K T S
from the course, your vessel's position, and so on. To display the
69 . 3
F T
information mentioned above, however, it is necessary to connect a
15.7
N M
GPS/DGPS sensor (optional) and activate Navigational equipment.
Notes:
• To display the vessel heading marker and HDG (Vessel heading), it is
8:28AM necessary to receive the vessel heading data in the NMEA0183 standard
format. You need to connect the specified signal line to the NMEA
connector or DC12V/ COMPASS connector on the rear panel to receive
S O F T
K E Y
the vessel heading data.
• To display the water depth data, it is necessary to receive the depth data in
the NMEA0183 standard format. You need to connect the specified signal
line to the NMEA connector on the rear panel to receive the water depth
data.
• To display the speed through the water (STW), it is necessary to receive the
speed through the water data in the NMEA0183 standard format. You
need to connect the specified signal line to the NMEA connector on the
rear panel to receive the water speed data.
MPH=mile/hour)
M=magnetic)
steer (unit:0.1 NM)