Table of Contents
Advertisement
32
Belt fitting method
GPS/DGPS
Sensor
Cable
1. Loosen the fitting belt screw
with a screwdriver and
remove the clamp.
Clamp
Minus screw driver
Figure 2-7 Belt Fitting Method
ATTENTION
• Do not fasten the junction of connectors with the
fitting belt.
It may cause connector damage.
• Do not coil the fitting belt around the aluminum base.
The aluminum base will be scratched with the belt
and may cause corrosion.
Plastic
Mounting
Unit
2. Coil the fitting belt around
the mast as shown below.
Do not coil the fitting
belt around the
aluminum base.
20mm
(Sensor case bottom
to Mast top)
Fitting belt
Mast
(ø26- ø50)
3. Tighten the clamp screw
with a screwdriver.
Advertisement
Table of Contents
