Table of Contents
Advertisement
Inserting a Chart Card
q Check that the card is C-MAP NT C-Card with the required chart stored on
it.
w Open the card cover, at the higher left of the display front panel.
e Hold the card with the title label towards the left and upside down, as shown
in the illustration.
r Gently push the card into one of the two slots. It will only go in if it is the
correct way round. Push the card in as far as it will go, then move it to the
right so that the top is under the retaining pegs. The card will be held in
place by the pegs.
t Close the card cover so that it clicks shut, to prevent water from entering the
display unit.
Removing a Chart Card
q Open the card cover, at the higher left of the display front panel.
w Push the card in to disengage from the pegs, then remove it.
e Close the card cover so that it clicks shut, to prevent water from entering the
display unit.
Note:
• Turn off the power when removing the chart card.
Removing the chart card when the chart is being updated may cause an erroneous
chart to be displayed. If an erroneous chart is displayed, do enlarge/reduce and re-
display the chart.
Figure 2-13
41
Advertisement
Table of Contents
