Table of Contents
Advertisement
Note:
There may be 2 positions where the targets are strong. Select the one that
has the larger value of "TUNE PRESET".
• Push the
to save and exit.
Joystick
Relative BEARING alignment
This adjustment should be performed after installation or a master
reset to avoid incorrect bearing readouts and picture orientation. Using
the 1.5 NM range, identify a small target such as a boat or buoy that
can be seen both visually and on the radar. Point the boat so the target
is visually dead ahead. If the radar target does not also show on the
heading line proceed with this adjustment. In the Radar Adjust menu
select BEARING by
Joystick
selecting by pushing the
Line (EBL) by
Joystick
be dead ahead. Push the
and push the
Joystick
indicated.
DISPLAY TIMING
This step must be performed. Failure to perform this step may
result in incorrect target distance reading.
• Set the range scale to 0.25 NM.
• Locate a pier, a jetty, a bridge (close to water line) or any other straight
object. Position the vessel so that it appears on the display. It does not
matter which way you are facing.
• In the RADAR ADJUST menu, select DISPLAY TIMING by
up/down, and push
Joystick
The DISPLAY TIMING pop-up menu is displayed.
• If the bridge, pier or jetty does not appear to be in a straight line on
the display, then the DISPLAY TIMING needs to be adjusted.
• Use the
right/left to adjust the timing and make the object
Joystick
appear straight on the display.
• Press
when done.
Joystick
STC PRESET
This step must be performed. Failure to perform this step may
result in incorrect sea clutter suppressing.
• Set the range scale to 6 NM.
• Turn IR off, STC to maximum, and set gain to maximum.
• In the RADAR ADJUST menu, select STC PRESET by
up/down, and push
The STC PRESET pop-up menu is displayed.
• Use the
to remove all background noise from 0-3 NM.
Joystick
• Press
when done.
Joystick
up/down, moving the hiliter, and
. Move the dashed Electronic Bearing
Joystick
left/right to bisect the radar target that should
once. Move the EBL to dead ahead
Joystick
again to rotate the picture by the offset just
.
Joystick
.
Joystick
DISPLAY TIMING
STC PRESET
Joystick
BEARING
0
840
57
39
Advertisement
Table of Contents
