Data In/Out; Temp. In (Selecting Temperature Input) - JRC RADAR 1800 Instruction Manual

PRF SHIFT
20
DATA IN OUT
TEMP. IN NMEA
DEPTH IN NMEA
POSITION IN GPS
NMEA OUT
98
[PRF SHIFT]
• In case of dual radar installed or received other radar's signal, which
radar use same PRF (Pulse Repetition Frequency), sometime appeared
strong interference as a concentric circle. In this case you can avoid
strong interference by PRF shift.
• Select PRF SHIFT at the RADAR ADUST menu, press the
the PRF SHIFT popup menu is displayed. You can change PRF by
right or left, after adjusting press
Joystick
(Refer to "INTERFERENCE REJECTION" p.62)
[BEARING] (Relative BEARING alignment)
Refer to "Relative BEARING alignment" p.39.
[DISPLAY TIMING]
Refer to "DISPLAY TIMING" p.39.
[TUNE PRESET]
Refer to "TUNE PRESET" p.38.
[STC PRESET]
Refer to "STC PRESET" p.39.

DATA IN/OUT

• In this menu, you can set the RADAR 1800 so that you can get the
data such as water temperature or vessel's speed, or issue the data in
the specified format.

TEMP. IN (Selecting temperature input)

• In this menu, you can select the water temperature data input from
the external NMEA source or OFF. When NMEA is selected, the
water temperature input from the external water temperature gauge is
displayed.
Note:
• When you input the water temperature data from an external water
temperature gauge, you need to connect the specified signal line to the
NMEA connector on the rear panel. In addition, be sure to check that the
NMEA0183 sentences of $xxMTW are output from the connected water
temperature gauge. (You can check this easily using the self test mode of the
RADAR 1800.)
Joystick
.
Joystick
,