Console Mounting/ Surface Mounting - JRC RADAR 1800 Instruction Manual

Console Mounting/ Surface Mounting

ATTENTION
Make sure there are no hidden electrical wires or other
items behind the desired location before proceeding.
Also check that you have free access for mounting and
cabling.
1) Select a mounting location: a clear, flat area of at least 8"(203mm) wide by 8"
high, having 5.5"(140mm) depth behind the panel. At that time, make sure
that there are no hidden electrical wires or other items behind your selected
location before proceeding.
2) Tape the mounting template from the console mounting instruction over your
selected location on the panel and trace around the edges.
3) Drill a 1/2"(12.7mm) pilot hole at the top and bottom of the cut-out area.
4) Cut along the outside edge of the cut-out line with an appropriate saw.
5) Drill holes, using a 1/5"(5mm) drill bit, for the four threaded screws, 2 on
each side, on the mounting template.
6) Remove the yoke, two knobs, two spacers and two damping rubbers from the
unit, then securely attach the threaded screws to the rear cabinet and verify
that the unit will fit inside the cut-out area.
7) Complete installation of the DC power, Scanner, GPS, NMEA and ground
wiring into the console and make the connections onto the rear of the unit.
8) Place the unit into the cut-out and fit the washers, lock-washers, onto the
threaded screws behind the mounting console, and tighten the nut to hold the
unit in place.
1 SCREW
2 NUT
3 WASHER
4 LOCK WASHER
Illustration above shows the
way of Console Mounting.
61 (2.4)
82 (3.2)
94.5 (3.7)
65.5 (2.6)
6.5 (0.3) 191 (7.5)
45.5 (1.8)
Illustration above shows the
cut-out size of the mounting
in the console.
Figure 2-2
54.5 (2.1)
4-R4 (0.2)
44.5 (1.8)
50 (2)
65.5 (2.6)
4- 5 ( 0.2)
100 (3.9)
6.5 (0.3)
45.5 (1.8)
Unit : mm (inch)
27