Switching From 'Home' To 'Away; Switching From 'Away' To 'Home; Arming 'Instant; Forced Arming - Visonic POWERMAXCOMPLETE User Manual

SECURING THE PROTECTED SITE

Switching from 'HOME' to 'AWAY'

Do not disarm the system - just press
response will be the same as in ARMING AWAY above.
Vacate the premises before the exit delay expires.

Switching from 'AWAY' to 'HOME'

Do not disarm the system - just press
this operation reduces the security level, the
PowerMaxComplete will ask you to key in your
master user code or user code, thus making sure
that you are an authorized user.
PRESS RESULTANT DISPLAY
ENTER CODE
[Enter code] ARMING HOME
Move to
interior zone
ARM HOME
ARM indicator flashes during the armed state.
If an alarm occurred while the system was armed in
the AWAY mode, the display will respond differently:
PRESS RESULTANT DISPLAY
ENTER CODE
[Enter code] ARMING HOME
Move to
interior zone
HOME
ARM HOME MEMORY
ARM indicator flashes during the armed state.

Arming 'Instant'

You may arm AWAY or HOME without an entry
delay - any detection in any zone will trigger an
immediate alarm.
If you wish to arm AWAY-INSTANT, proceed as follows.
PRESS RESULTANT DISPLAY
ARMING AWAY
ARMING INSTANT
PLEASE EXIT NOW
Vacate the
premises
AWAY
10
. The
. Since
_ _ _
↓ (Exit delay) ↓
HH:HH
_ _ _
↓ (Exit delay) ↓
HH:HH
(alternating)
(alternating)
↓ (Exit delay) ↓
ARM indicator lights during the armed state.
If you wish to arm HOME-INSTANT, proceed as follows:
PRESS RESULTANT DISPLAY
ARMING HOME
ARMING INSTANT
ARMING HOME
Go to an
internal zone
ARM HOME
ARM HOME INSTANT
ARM indicator flashes during the armed state.

Forced Arming

Forced arming allows you to arm any system
partition even though one zone or several zones are
disturbed, and the NOT READY message is
displayed.
Automatic forced arming only works if the installer
allowed this option while programming your system.
Disturbed zones will be bypassed - they will not be
armed. The protected site will not have maximum
protection.
Note: When forced arming is carried out, the buzzer
"protests" by emitting a continuous tone during the exit
delay until the last 10 seconds of the delay. You can
silence this signal by pressing the arming button again.
When NOT READY is displayed, Forced arming
"AWAY" is performed as follows:
PRESS
(to mute
the buzzer)
ARM indicator lights during the armed state.
When NOT READY is displayed, Forced arming
"HOME" is performed as follows:
PRESS RESULTANT DISPLAY
ARMING HOME
(To
mute the buzzer)
Go to interior zone
HOME
ARM indicator flashes during the armed state.
(alternating)
↓ (Exit delay) ↓
HH:HH
(alternating)
RESULTANT DISPLAY
ARMING AWAY
↓
PLEASE EXIT NOW
↓ ↓
(Exit delay)
AWAY
↓ (Exit delay) ↓
HH:HH
D-302755