Visonic POWERMAXCOMPLETE User Manual page 20

B. Executable Commands
Command
1 Disarming
2 Arming Home
3 Arming Home-Instant
4 Arming Away
5 Arming Away-Instant
6 Arming Away-Latchkey
7 Arming Away-Instant-Latchkey
8 Review status of specific partition
(Voice version only) (*)
9 Activating PGM output
10 Deactivating PGM output
11 Two-way voice communication
(Voice version only) (see sub-par.
C)
12 Recorded message playback
13 Recorded message start record
14 Recorded message stop record
15 Recorded message erase
message
16 Investigating system status (Voice
version only)
17 Quit (end communication)
* This command operates on ALL permitted partition(s).
C. Two-Way Voice Communication
Perform steps 1-6
Communication above and continue as follows:
1. [ ] [7] [ #]
2. Wait for 2 beeps
3. [3] or [1] or [6] (see below)
The system will start to function in the "LISTEN IN"
mode, letting you hear the sounds within your residence
for 50 seconds. If the person under surveillance
happens to speak or cry then, you will hear this. You
can switch the system to Listen-In, Speak Out or Full
Duplex, as shown in the next table.
Command
Listen-in (listening to the person at home) (*)
Speak-out (speaking to the person at home) (*)
Full-duplex (listening & speaking) (*)
Note: To prolong the communication session
by 50 seconds, press [3], [1] or [6] again, as
required.
* The 2-way communication can be terminated by
anyone close to the PowerMaxComplete, by
disarming the system.
D-302755
Single Partition Keying
Sequence
[ ] [1] [#]
[ ] [2] [#]
[ ] [2] [ 1] [#]
[ ] [3] [#]
[ ] [3] [1] [#]
[ ] [4] [#]
[ ] [4] [ 1] [#]
[ ] [5] [0]
[ ] [5] [0]
[ ] [7] [ #]
[ ] [8] [ 1 ]
[ ] [8] [ 2 ]
[ ] [8] [ 3 ]
[ ] [8] [ 4 ]
[ ] [9] [#]
[ ] [9] [9] [#]
in Establishing Telephone
[0] [1] [#]
[0] [0] [#]
[#]
[#]
[#]
[#]
Remark Regarding Listen-in & Speak-out modes
Listen-in & Speak-out modes allow one way speech at
a time. Back and forth exchange of uninterrupted
speech between two parties is a method normally
used in military, commercial and amateur radio
communication. Once you finish talking you should
say "Go Ahead" or "Over" and then switch from speak-
out to listen in. When the person at home finishes
talking he should also say "Over", as a cue to you to
switch back from Listen-in to speak out.
EXAMPLE:
You (at remote telephone):
can you hear me? Are you in any trouble? Over"....
[3]
Key
Person at home: "Yes, I am. I had a dizzy spell while
[3]
trying to get out of bed and fell on the floor. I am
[1]
unable to get up and my thigh hurts. Can you help
me? Over"...
[6]
You (at remote telephone):
send someone right away, stay put - over"..
Person at home: "Thanks, please hurry, over".
You (at remote telephone):
and out".....
SPECIAL FUNCTIONS
All Partitions Keying Sequence /
Partition Disable
[ ] [0] [partition] [1] [#]
[ ] [0] [partition] [2] [#]
[ ] [0] [partition] [2] [ 1] [#]
[ ] [0] [partition] [3] [#]
[ ] [0] [partition] [3] [1] [#]
[ ] [0] [partition] [4] [#]
[ ] [0] [partition] [4] [ 1] [#]
[ ] [0] [partition] [9] [#]
[ ] [5] [device No.] [1]
[ ] [5] [device No.] [0]
[ ] [7] [ #]
[ ] [8] [ 1 ]
[#]
[ ] [8] [ 2 ]
[#]
[ ] [8] [ 3 ]
[#]
[ ] [8] [ 4 ]
[#]
[ ] [9] [#]
[ ] [9] [9] [#]
[1], "Hey, George,
[1], "All right, over
[ ] 9] [9] (END OF SESSION).
[ #]
[ #]
[1], "Sure, I will
[3].
19