Reporting To Private Telephone; Remote Control By Sms - Visonic POWERMAXCOMPLETE User Manual

SPECIAL FUNCTIONS
Important! If you wish
communication mode
command, just press [ ] and then key your user
code followed by the command (see "keying
sequences" in Executable Commands table above).

Reporting to Private Telephone

control
panel
The PowerMaxComplete can be programmed by the
installer for selective transmission of messages to
private telephone subscribers. Messages are divided
by type into 4 groups:
Group Events Reported
1 Fire (*), Burglary (**), Panic, Tamper
2 Arming AWAY, Arming HOME, Disarming
3 No-activity, Emergency (***), Latchkey,
Gas, Flood, Temperature
4 Low-battery AC failure
Note: In control panel with no-voice option, the
following siren signal will be sent to private telephone
upon event reporting:
* FIRE: ON - ON - ON - pause.... (- - - - - - ......).
** BURGLAR: ON continuously (
*** EMERGENCY: 2-tone siren; like an ambulance.
When the called party answers a call initiated by the
PowerMaxComplete, he will hear a verbal message
composed of the "house identity" and the type of
event that occurred. For example, once smoke is
detected in the Smith residence, the message will
be: [The Smith Residence - Fire Alarm].
If a person under surveillance in the Watkins
residence has been inactive, the message will be:
[The Watkins Residence - No Activity].
The called party must acknowledge the message (as
explained later on), but if he does not respond, the
message will be transmitted repeatedly as many
times as possible within a 45-second time limit.
When the 45
PowerMaxComplete will disengage the line and call
the next private telephone number on its list.
The called party can acknowledge the message by
pressing a key on the telephone keypad, as follows.
Command
Acknowledge
PowerMaxComplete
line and considers the event duly
reported.
20
to exit the two-way
and execute another
seconds are up,
Key
only: The
disengages the
Command
Acknowledge
protected site is "bugged" for sound for
50 seconds. The called party may
prolong
pressing
PowerMaxComplete
line, or by pressing [1] to speak.
Acknowledge and speak out: The
called party may speak for 50 seconds
to whoever is in the protected site. The
called party may prolong the "speak
out" session by pressing [1] again
before
disengages the line, or by pressing [3]
to listen.
Acknowledge and 2-way conversation:
You and the called party can speak and
listen without any necessity to switch the
system from "listen-in" to "speak-out"
and vice versa for 50 sec. (extendable).
Acknowledge and request a status
report: The PowerMaxComplete will
issue a verbal report of system status.
For example:
...)
[Disarm - ready to arm] or
[Disarm - back door open] or
[Disarm - alarm in memory].

Remote Control by SMS

PowerMaxComplete system with an optional internal
GSM unit can respond to SMS commands from any
cellular GSM telephone, only if the "REM ACCESS
ON" command was pre-selected by the system
installer.
The various SMS commands are detailed in the
following table (the detailed SMS message sending
process is described in the cellular telephone user's
the
guide). In this table, "<code>" means 4-digit user
code and blank space simply means blank space.
In the following table, "P#" is used only for
PowerMaxComplete with partition enabled - use P1,
P2, P3, or P4, according to the partition number.
2
and listen-in:
the listening session
[3] again before
disengages
the PowerMaxComplete
SMS Command List
Key
The 3
by
the
the
1
6
9
D-302755