Deleting Proximity Tags; Setting The Voice Options; Automatic Arming Option - Visonic POWERMAXCOMPLETE User Manual

USER SETTINGS
D. Present the tag to the control panel left bottom
side. In response, the "Happy Tune" (- - - –––) will
sound and the display will change to:
T a g N o :
A dark box will appear at the far right, indicating that
the chosen tag has been enrolled.
E. Click
tag (2, 3,...8), as described in step D.
F. From this point on, you may continue in several
different directions:
• If you wish to enroll another tag, select the
desired number by:
- Clicking
- Clicking
- Clicking
• To return to the main menu, click
will bring back the display:
< O K > T O E X I T
You may now review and select any other mode on
the User menu (by clicking

Deleting Proximity Tags

Proximity tag memory locations must be cleared
(enrolled ID must be deleted) before enrolling a new
ID. To delete an existing ID, proceed as follows:
A. Select the desired memory location, as described
in the previous paragraph, steps A-C. If, for
example, you selected Tag No. 5, the display will
read:
T a g N o .
B. Click . The display will change to:
< O F F > T O D E L E T E
C. Click . The display will change to:
T a g N o .
Note that the dark box at the far right has
disappeared. It is now possible to enroll a new ID. It
is also possible to leave the cleared zone or memory
location free and simply exit to the main menu.

Setting the Voice Options

(Not applicable in PowerMaxComplete that does not
have VOICE option)
Remember: Voice prompts are heard over the built-
in loudspeaker subject to two conditions:
- The voice option is enabled as shown below
- The loudspeaker is enabled by pressing the "7"
key (see Chapter 3 - Voice ON-OFF)
30
1
and enroll the next proximity
to go up (6 7 8.....)
to go down (4 3 2.....)
<tag#>.
or
5
5
Here you may select one of two options:
Enable prompts: Voice announcements
Disable prompts: No voice announcements
The presently programmed option will be shown, with
a dark selection box ( ) at the far right of the
display. You may view the other option (that does not
have a dark box at the far right) by clicking
To set the voice option, proceed as follows:
Having entered your Master User Code successfully
(see above - Entering the User Settings Menu), click
the
From here, proceed as follows:
PRESS
. This
If not satisfied
).
If satisfied -
You may now select any other item on the USER
SETTINGS menu or quit programming by clicking
. When <OK> TO EXIT is displayed - click
Note: When using the Model MCT-234 keyfob with the
PowerMaxComplete, the voice prompts must be
enabled.

Automatic Arming Option

You can determine that the system will be
automatically armed at any desired time.
Having entered master user code successfully, click
displayed.
From here, proceed as follows:
PRESS
If not satisfied
press
. A dark box will appear if you click
while the other option is displayed.
button until the display reads:
SET VOICE OPTIONS
RESULTANT DISPLAY
enable prompts
(if this is the current option)
disable prompts
disable prompts
SET VOICE OPTION
.
until AUTO ARM
RESULTANT DISPLAY
enable autoarm
(if this is the current option)
disable autoarm
disable autoarm
AUTO ARM OPTION
OPTION is
D-302755