Sco; Information Checklist; Procedure - Xerox 4250 - WorkCentre - Copier System Administration Manual

3 Network Installation
tty Method
1. Enter su to access Super User mode.
2. Enter sh to run the Bourne shell.
3. Define the machine as a BSD style printer, by entering the command:
lpsystem -t bsd hostname
Where hostname is the machine hostname from the /etc/hosts file.
4. Create the queue, by entering the command:
lpadmin -p queuename -s hostname -T unknown -I any
Where queuename is the name of the queue being created.
5. Enter Exit to exit the Bourne shell
6. Enter Exit to exit Super User mode.
7. Test the queue created, by entering the command:
lp -d queuename /etc/hosts.
8. Verify that the job prints at the machine.

SCO

SCO UNIX workstations require specific installation steps to communicate with the
machine. The machines are BSD-style UNIX printers, whereas SCO is a System V-style UNIX.

Information Checklist

Before starting the Installation procedure, please ensure that the following items are
available and/or the tasks have been performed:
1. Existing operational network utilising the TCP/IP protocol.
2. Ensure that the machine is connected to the network.
3. Static IP Address for the machine.
4. Subnet Mask Address for the machine.
5. Gateway Address for the machine.
Host Name for the machine.
6.

Procedure

1. Follow the steps in Chapter 3, Configure Static IPv4 Addressing using the Machine
User Interface, Procedure on page 14 until step 38, then return to this page.
Configure the Client
1. Add the machine printer hostname to the etc/hosts file on the SCO workstation.
2. Ensure that you can Ping the machine from the SCO workstation.
Perform the following steps to create a machine print queue on a SCO UNIX
workstation using either the GUI or the TTY method.
26 Xerox WorkCentre 4250/4260 Series System Administration Guide