Transmitter Displays & Buttons - FUTABA T10J Manual

TRANSMITTER DISPLAYS & BUTTONS
When you first turn on your transmitter, a confirmation double beep sounds, and the screen shown
below appears. Before flying, or even starting the engine, be sure that the model type and name
appearing on the display matches the model that you are about to fly! If you are in the wrong model
memory, servos may be reversed, and travels and trims will be wrong, potentially leading to a crash.
Edit buttons and Start-up Screen (appears when system is first turned on):
Total timer display <TIMER>
Shows the cumulated ON time. (hours:minutes)
Up/down timer display <ST1.ST2>
(minutes:seconds)
Model timer display <MDL>
Shows the cumulated ON time for each model.(hours:minutes)
System timer display <SYS>
Shows the cumulated ON time.(hours:minutes)
Resetting timers:
Select the desired timer with JOG KEY. The timer display
flashes. To reset the timer, press JOG KEY.
Throttle trim
END
Key
JOG KEY:
Control JOG KEY to scroll up/scroll down/scroll left/scroll right and select the option to edit within a
function. When the menu has multiple pages, move the JOG KEY horizontally (left or right).
Press JOG KEY to select the actual function you wish to edit from the menu.
Press JOG KEY and hold one second to confirm major decisions, such as the decision to: select
a different model from memory, copy one model memory over another, trim reset, store channel
position in FailSafe, change model type, reset entire model, condition of a helicopter setup is changed.
An on screen inquiry will ask if you are sure.
Press JOG KEY again to accept the change.
＋ KEY:
Press and hold ＋ KEY for one second to open programming menus. It is used for changing a setup,
or a numerical increase. Changing the menus pages can also be performed.
－ KEY:
It is used for change of a setup, or reduction of a number. Change of the page of a menu can also be
performed.
END BUTTON:
Press END BUTTON to return to previous screen, close functions back to menus, and close menus to
start-up screen.
Timers
Model number
and name
display
Rudder trim
display
Press and hold ＋ KEY for one
second to open programming
menus.
Model type
System
"S-FHSS" "FHSS"
Output display
Battery
voltage Telemetry
Receiving accuracy
Elevator trim
display
Aileron trim
display
－ key
＋
key
Jog key
25