System Statistics; Dhcp Table Screen; Figure 93 System Status: Show Statistics; Table 78 System Status: Show Statistics - ZyXEL Communications ZyAir G-2000 PlusV2 User Manual

18.2.1 System Statistics

Read-only information here includes port status, packet specific statistics and bridge link
status. Also provided are "system up time" and "poll interval(s)". The Poll Interval field is
configurable.

Figure 93 System Status: Show Statistics

The following table describes the labels in this screen.

Table 78 System Status: Show Statistics

LABEL
Port
Status
TxPkts
RxPkts
Collisions
Tx B/s
Rx B/s
Up Time
System Up Time
Poll Interval(s)
Set Interval
Stop

18.3 DHCP Table Screen

DHCP (Dynamic Host Configuration Protocol, RFC 2131 and RFC 2132) allows individual
clients to obtain TCP/IP configuration at start-up from a server. You can configure the ZyXEL
device as a DHCP server or disable it. When configured as a server, the ZyXEL device
provides the TCP/IP configuration for the clients. If set to None, DHCP service will be
disabled and you must have another DHCP server on your LAN, or else the computer must be
manually configured.
Chapter 18 Maintenance
DESCRIPTION
This is the WAN, LAN or WLAN port.
This shows the port speed and duplex setting if you are using Ethernet
encapsulation for the Ethernet port.
This shows the transmission speed only for wireless port.
This is the number of transmitted packets on this port.
This is the number of received packets on this port.
This is the number of collisions on this port.
This shows the transmission speed in bytes per second on this port.
This shows the reception speed in bytes per second on this port.
This is total amount of time the line has been up.
This is the total time the ZyXEL device has been on.
Enter the time interval for refreshing statistics.
Click this button to apply the new poll interval you entered above.
Click this button to stop refreshing statistics.
ZyXEL G-2000 Plus v2 User's Guide
225