System Timeout; Www Screen; Telnet Screen - ZyXEL Communications NBG5715 User Manual

Chapter 20 Remote Management
• Use the NBG5715's WAN IP address when configuring from the WAN.
• Use the NBG5715's LAN IP address when configuring from the LAN.

20.3.2 System Timeout

There is a default system management idle timeout of five minutes (three hundred seconds). The
NBG5715 automatically logs you out if the management session remains idle for longer than this
timeout period. The management session does not time out when a statistics screen is polling. You
can change the timeout period in the System screen

20.4 WWW Screen

To change your NBG5715's remote management settings, click Management > Remote MGMT to
open the WWW screen.
Figure 91 Management > Remote MGMT > WWW
The following table describes the labels in this screen.
Table 66 Management > Remote MGMT > WWW
LABEL
Port
Access Status
Secured Client IP
Address
Apply
Cancel

20.5 Telnet Screen

To change your NBG5715's remote management settings, click Management > Remote MGMT >
Telnet to open the Telnet screen.
150
DESCRIPTION
You may change the server port number for a service if needed, however
you must use the same port number in order to use that service for
remote management.
Select the interface(s) through which a computer may access the
NBG5715 using this service.
Select All to allow all computes to access the NBG5715.
Otherwise, check Selected and specify the IP address of the computer
that can access the NBG5715.
Click Apply to save your customized settings and exit this screen.
Click Cancel to begin configuring this screen afresh.
NBG5715 User's Guide