Error Messages - Xerox Phaser 6115MFP User Manual

Error Messages

Message
TRAY [1] [2] EMPTY
*CANNOT
CONNECT*
XXX Server
*IP ADDRESS NOT
SET*
SMTP Server
*COMM. ERROR*
SMTP Server
*DISCONNECT*
SMTP Server
DOC. FEED COVER
OPEN
CLOSE DOC. FEED
COVER
DOCUMENT COVER
OPEN
CLOSE DOCUMENT
COVER
IMAGING UNIT
END
IMAGING UNIT
LOW
IMAGING UNIT
NOT INSTALLED
IMAGING UNIT END
CHANGE DRUM
DUPLEX COVER
OPENCLOSE
DUPLEX COVER
FILE FULL
PRESS ANY KEY
Definition
Tray 1 or Tray 2 ran out of paper.
While the scanned document
was being sent in Scan mode, a
connection with the specified
server could not be established.
The IP address of the SMTP
server could not be obtained
from the DNS server.
While data was being sent in
Scan mode, the connection to
the server was cut.
In Scan mode, the connection to
the server was cut.
The ADF feed cover is open.
The document is loaded into the
ADF, but the ADF is open.
The drum cartridge has reached
the end of its service life.
The drum cartridge is near the
end of its life.
The drum cartridge is not
installed.
The waste toner bottle in the
drum cartridge is full.
Duplex cover is open.
The memory has becomes full
while scanning a document in
Scan mode.
Phaser® 6115MFP Multifunction Product
11-34
Status, Error, and Service Messages
Solutions
Load media into the specified tray.
Check the Network and E-mail
settings and send the data again.
Check the Network and E-mail
settings and send the data again.
Check the Network and E-mail
settings and send the data again.
Check the Network and E-mail
settings and send the data again.
Close the ADF feed cover.
Close the ADF.
Replace the drum cartridge.
Prepare a new drum cartridge.
Install the drum cartridge.
Replace the drum cartridge.
Close the duplex cover.
Turn the machine off, and then, after
waiting a few seconds, turn it on
again.
Decrease the amount of data to be
scanned (for example, by decreasing
the resolution), and then try scanning
again.