Xerox Phaser 6115MFP User Manual page 24

New Zealand Telecom Warning Notice
1. The grant of a Telepermit for any item of terminal equipment indicates only that Telecom
has accepted that the item complies with minimum conditions for connection to its
network. It indicates no endorsement of the product by Telecom, nor does it provide any
sort of warranty. Above all, it provides no assurance that any item will work correctly in
all respects with another item of Telepermitted equipment of a different make or model,
nor does it imply that any product is compatible with all of Telecom's network services.
The equipment may not be capable of correct operation at the higher data speeds
designated. 33.6 kbps and 56 kbps connections are likely to be restricted to lower bit rates
when connected to some PSTN implementations. Telecom will accept no responsibility
should difficulties arise in such circumstances.
2.
Immediately disconnect this equipment should it become physically damaged, and arrange
for its disposal or repair.
3.
This modem shall not be used in any manner which could constitute a nuisance to other
Telecom customers.
4.
This device is equipped with pulse dialing, while the Telecom standard is DTMF tone
dialing. There is no guarantee that Telecom lines will always continue to support pulse
dialing.
Use of pulse dialing, when this equipment is connected to the same line as other
equipment, may give rise to 'bell tinkle' or noise and may also cause a false answer
condition. Should such problems occur, the user should NOT contact the Telecom Faults
Service.
The preferred method of dialing is to use DTMF tones, as this is faster than pulse
(decadic) dialing and is readily available on almost all New Zealand telephone exchanges.
5. Warning Notice: No '111' or other calls can be made from this device during a mains
power failure.
6. This equipment may not provide for the effective hand-over of a call to another device
connected to the same line.
7. Some parameters required for compliance with Telecom's Telepermit requirements are
dependent on the equipment (PC) associated with this device. The associated equipment
shall be set to operate within the following limits for compliance with Telecom's
Specifications:
For repeat calls to the same number:
■ There shall be no more than 10 call attempts to the same number within any 30 minute
period for any single manual call initiation, and
■ The equipment shall go on-hook for a period of not less than 30 seconds between the
end of one attempt and the beginning of the next attempt.
For automatic calls to different numbers:
■ The equipment shall be set to ensure that automatic calls to different numbers are
spaced such that there is no less than 5 seconds between the end of one call attempt
and the beginning of another.
8. For correct operation, total of the RN's of all devices connected to a single line at any time
should not exceed 5.
Phaser® 6115MFP Multifunction Product
1-16
Fax Regulations