Xerox Phaser 6115MFP User Manual page 160

Keep the following guidelines in mind:
■ Be careful when cleaning the inside of the product or removing media misfeeds, as the
fuser and other internal parts may be very hot.
Do not place anything on top of the product.
■
■ Use a soft cloth to clean the product.
■ Never spray cleaning solutions directly on the product's surface; the spray could penetrate
through the air vents of the product and damage the internal circuits.
■ Avoid using abrasive or corrosive solutions or solutions that contain solvents (such as
alcohol and benzene) to clean the product.
Always test any cleaning solution (such as mild detergent) on a small inconspicuous area
■
of your product to check the solution's performance.
■ Never use sharp or rough implements, such as wire or plastic cleaning pads.
■ Always close the product's covers gently. Never subject the product to vibration.
■ Do not leave the product's covers open for any length of time, especially in well-lit places.
Light exposure can damage the imaging unit.
■ Do not open the product's covers during printing.
■ Do not lubricate or disassemble the product.
■ Do not tilt the product while in use.
■ Do not touch the electrical contacts, gears, or laser devices. Doing so may damage the
product and cause the print quality to deteriorate.
■ Keep media in the output bin at a minimum level. If the media is stocked too high, your
product may experience media misfeeds and excessive media curl.
■ Make sure any parts removed during cleaning are replaced before you plug in the product.
Phaser® 6115MFP Multifunction Product
10-3
Maintenance and Cleaning