Yamaha 01V96i Reference Manual page 31

EQ'ing the Stereo Out and Bus
Outs
To set the EQ for the Stereo Out and Bus Out 1–8 EQ, press
the DISPLAY ACCESS [EQ] button, then press the [F1] but-
ton to display the EQ | EQ Edit page, and use the [SEL] but-
tons to select the Stereo Out or Bus Out 1–8.
The parameters on this page (and the procedure for setting
them) are the same as for Input Channels (see page 21). Note
that the Stereo Out does not feature the STEREO LINK
parameter.
Routing Bus Out 1–8 Signals to
the Stereo Bus
You can patch Bus Out 1–8 signals to Outputs and Slot, as well
as to the Stereo Bus. You can adjust the level and pan settings
of the signals routed to the Stereo Bus for each bus. This is
convenient when you wish to use Bus Outs (1–8) as a Group
Bus.
To patch the Bus Out 1–8 signals to the Stereo Bus, press the
DISPLAY ACCESS [PAN/ROUTING] button repeatedly to
display the Pan/Route | Bus to St page.
1
2
3
Move the cursor to the desired parameter you wish to change,
then rotate the Parameter wheel or press the [INC]/[DEC]
buttons to modify the setting.
1
TO ST PAN
These controls pan the Bus Out 1–8 signals between the
left and right Stereo Out buses.
Setting the Stereo Out and Bus Out 1–8 from the Display
2
TO ST ON/OFF
These buttons turn on and off the Bus Out 1–8 to the Ste-
reo Bus routing.
3
TO ST Faders
These faders set the Bus Out 1–8 to Stereo Bus levels.
Viewing the Stereo Out and Bus
Out Settings
You can view and adjust parameter settings for the cur-
rently-selected Stereo Out or Bus Out on the View | Parameter
and Fader pages.
■ Viewing the Compressor and EQ
Settings
To display the View | Parameter page, use the corresponding
[SEL] button to select the desired bus, then press the DIS-
PLAY ACCESS [VIEW] button, then press the [F1] button.
The parameters on this page (and the procedure for setting
them) are the same as for Input Channels, except for the fol-
lowing items:
• The Stereo Out and Bus Out 1–8 Parameter pages do not
contain the Gate and Phase parameters.
• The Stereo Out Parameter page does not contain the Pair
parameter.
31
01V96i—Reference Manual