Table of Contents
Advertisement
•
Use the adjusting screws (arrow) to adjust play of
the throttle cables.
•
Push the rubber cap into position over the ad-
justing screw.
Play of throttle cable: ..... approx. 0.5 mm (0.02 in)
•
Use the adjusting screw (arrow) to adjust play of
the choke cable to zero.
•
Push the rubber cap into position over the ad-
justing screw.
•
Move the handlebars all the way from left to right
and check the settings. Make sure that engine
speed does not vary when the handlebars are
moved in this way.
•
Repeatedly open the throttle gradually and in-
crease engine speed from idle to approximately
-1
n = 2500 min
to check throttle-valve synchroni-
sation. (Readings shown by Synchro tester must
increase and decrease together). If necessary,
correct by turning the adjusting screws of the
connecting cable.
L
Note:
Make sure that when the throttle grip is released
both throttle valves return to their fully closed posi-
tions.
•
Tighten the locknuts and recheck carburettor
balance.
•
Seal off the vacuum bores.
00.38
Final inspection with road safety
and functional check
(Inspections I, II, III and IV)
Road safety check
•
Check wheels and tyres.
•
Check/correct tyre pressures.
•
Wait at least 10 minutes after the trial run/road
test before checking/correcting engine oil level.
Tyre pressures:
Solo ..................................... front 2.2 bar (31.3 psi)
............................................. rear 2.5 bar (35.6 psi)
Two up ................................. front 2.5 bar (35.6 psi)
S000090
............................................. rear 2.7 bar (38.4 psi)
Two up + luggage ................ front 2.5 bar (35.6 psi)
............................................. rear 2.9 bar (41.2 psi)
Roadworthiness check
•
Lights
•
Telltale/warning lights
•
Horn
•
Instruments
•
Special equipment
•
Clutch
•
Gear shift
•
Steering
•
Foot brake and handbrake
•
If necessary, take the motorcycle for a test ride.
S000110
Advertisement
Chapters
Table of Contents
