•
Remove camshaft bearing cap (1).
•
Remove camshaft and bearing (2).
•
Remove bucket-type tappets.
e
Caution:
Do not mix up the bucket-type tappets.
•
Assembly is the reverse of the disassembly pro-
cedure.
e
Caution:
Note direction of installation (3) for camshaft bearing
cap. Rocker-shaft recess must be aligned with the
bores.
L
Note:
Locate pushrods in ball cups of rockers and hold the
rockers together with a rubber band to secure the
pushrods in position.
X
Tightening torque:
M 8 screw, rocker shaft bearing cap ............ 15 Nm
M 8 screw for camshaft bearing cap ........... 15 Nm
1
2
•
Adjust the holder for minimum end float.
End float of rockers:
min............................................ 0.05 mm (0.002 in)
max. ......................................... 0.40 mm (0.016 in)
3
RS110090
RS110100
11.23