Removing And Installing Fairing Bracket - BMW R 1100 S Repair Manual

Removing and installing fairing
bracket
e
Caution:
Switch off ignition.
Disconnect earth (ground) lead from battery.
Insulate earth (ground) lead.
•
Remove seat.
•
Remove fairing side sections.
•
Remove mirrors.
•
Remove windshield.
•
Disconnect headlight plug from socket at front
right fairing bracket.
•
Remove cable ties.
•
Remove front fairing panel complete with head-
light.
•
Disconnect plug of instrument panel.
•
Slacken the screws securing the instrument cover.
•
Remove retainers at bottom of instrument panel
and lift the instrument panel clear of its bearers.
•
Remove the instrument cover.
•
Remove left and right oil cooler lines from fairing
brackets.
•
Remove screws securing oil cooler to fairing
bracket.
•
Remove the horn.
•
Remove connector strips, wiring harness and
cables from fairing bracket.
•
Remove trim support bracket.
•
Installation is the reverse of the removal proce-
dure.
46.10
X
Tightening torques:
Fairing bracket to front frame ....................... 21 Nm
•
Switch on the ignition.
•
Without starting the engine, fully open the throttle
once or twice so that the Motronic control unit
can register the throttle-valve positions.
L
Note:
Disconnecting the battery deletes all entries (e.g.
faults, settings) stored in the Motronic control unit's
memory.
Loss of settings can temporarily impair the operat-
ing characteristics when the engine is restarted.
S460050