Removing And Installing Abs Unit; Removing The Abs Unit - BMW R 1100 S Repair Manual

5

Removing and installing ABS unit

e
Caution:
Work on the ABS unit must be performed by an au-
thorised BMW workshop.

Removing the ABS unit

•
Remove fuel tank.
•
Remove Motronic control unit.
•
Disconnect ABS brake lines (1) from ABS unit.
e
Caution:
If brake fluid escapes, it may damage paint.
Line connections must be protected against dirt
penetration; seal or cover ends of lines and ports.
1
3
4
•
Hold the front brake lever against the handlebar
grip with a rubber band (to close the brake fluid
feed bore).
e
Caution:
Switch off ignition, disconnect and insulate the
ground (earth) strap.
•
Remove cover (2) from ABS control unit, press
the lock in with a screwdriver and pull the cover
up.
•
Disconnect wires (3).
•
Pull off 2-pin plug (4).
•
Pull off the central plug (5).
•
Remove the ABS unit.
2
S340070
34.17