Installing Rear Swinging Arm - BMW R 1100 S Repair Manual

A

Installing rear swinging arm

•
Slide swinging arm over drive shaft as far as pos-
sible until rubber gaiter connects on housing
neck.
•
Install fixed bearing stud bolt (1).
•
Install floating-bearing stud bolt (2) with Loctite.
•
Tighten fixed bearing stud bolt.
•
Tighten floating bearing stud bolt.
•
Tighten locknut (3).
•
Secure suspension strut (1).
X
Tightening torques:
Swinging-arm fixed bearing stud bolt
to rear frame .................................................. 9 Nm
Swinging-arm floating-bearing stud bolt
to rear frame (clean thread + Loctite 2701)..... 7 Nm
Locknut ...................................................... 160 Nm
Suspension strut to swinging arm ................ 50 Nm
A
S330010
33.17