2
Disassembling and assembling rear
brake caliper
Disassembling rear brake caliper
•
Remove keeper (1).
•
Drive out retaining pin (2).
•
Remove brake pads.
•
Close the bleed screw.
X
Tightening torque:
Bleed screw in brake caliper .......................... 6 Nm
•
Hold a cloth over the brake caliper piston.
•
Carefully press out brake piston (3) with a com-
pressed air gun applied to the connecting bore;
work at low air pressure.
e
Caution:
Keep fingers away from gap between piston and
side contact face of brake pads; risk of injury.
•
Remove sealing rings (4) from left and right
bores.
•
Inspect the brake caliper piston for hairline
cracks, score-marks and other damage.
34.8
5
1
Assembling rear brake caliper
•
Coat the new sealing rings with brake fluid and
insert them into the left and right brake caliper
bores.
•
Coat both brake caliper pistons with brake fluid
and install them.
e
Caution:
Keep the brake pistons parallel to their bores when
installing.
•
Coat the adapter plate locating pins with
Shell Retinax A and install the adapter plate.
•
Insert locating plate (5) into brake caliper.
L
Note:
The installed position must be correct (arrow point-
ing in forward-travel direction).
•
Insert brake pads and secure with retainers.
3
4
GS340140