Removing and installing
throttle-valve potentiometer
Press in spring keeper of multi-pin plug for throt-
•
tle-valve potentiometer (1) and disconnect plug.
L
Note:
Do not remove throttle-valve potentiometer unless
due for replacement (basic setting is necessary —
see Motronic diagnosis instructions).
Remove the throttle-valve potentiometer.
•
Adjust throttle-valve potentiometer with
•
BMW MoDiTeC after installing.
Mark screws with a paint spot.
•
Removing and installing Motronic
control unit
Remove fuel tank.
•
e
Caution:
Switch off ignition; disconnect earth (ground) lead
from battery and insulate it.
Disconnect plug from Hall sensor.
•
Disconnect plug for engine-oil temperature.
•
Remove Motronic control unit.
•
Remove connector strip.
•
Installation is the reverse of the removal proce-
•
dure.
Switch on the ignition.
•
Without starting the engine, fully open the throttle
•
once or twice so that the Motronic control unit
can register the throttle-valve positions.
L
Note:
Disconnecting the battery deletes all entries (e.g.
faults, settings) stored in the Motronic control unit's
memory.
Loss of settings can temporarily impair the operat-
ing characteristics when the engine is restarted.
S130030
13.7