3
Removing and installing front wheel
Removing front wheel
•
Place the motorcycle on the auxiliary stand,
BMW No. 00 1 560.
•
The motorcycle is heavy at the nose; if neces-
sary, use a ratchet-lock belt to pull the motorcy-
cle down at the rear on the lifting platform.
•
Remove brake calipers.
L
Note:
Do not apply handbrake lever with brake calipers re-
moved or front wheel removed.
•
Remove retaining screw (1).
•
Loosen clamping screws (2).
•
Remove quick-release axle.
•
Remove spacing bushing (3/4) and front wheel.
Installing front wheel
•
Install front wheel and spacing bushings.
•
Apply a light coating of Molykote paste to the
quick-release axle and install.
•
Tighten the retaining screw (1).
•
Install the brake calipers.
•
Compress the front fork firmly several times.
•
Tighten the clamp screws (2).
•
[ABS] Check sensor gap and adjust if necessary.
ABS sensor gap:
........................... 0.45...0.55 mm (0.018...0.022 in)
2
4
X
Tightening torques:
Quick-release axle screw ............................. 30 Nm
Quick-release axle clamp screws ................. 22 Nm
Brake caliper to fork slider tube.................... 40 Nm
1
S360010
36.5