11
Assembling input shaft
•
Lightly oil the bearing surface for constant-speed
gear (1) on input shaft (10), and install the con-
stant-speed gear.
•
Lightly oil the splines in thrust block (2) and install
it.
•
Place anti-rattle disc (3) on thrust block (2).
•
Mount spring cluster (4) with locating ring (arrow)
facing upwards on anti-rattle disc (3).
•
Install backup washer (5) of the same thickness
as the original washer.
•
Compress spring cluster (4) and insert the split
segment washer (6) in the ring groove.
•
Install guide ring (7) with collar toward split-seg-
ment washer (6).
•
Check fully assembled length and adjust if nec-
essary (
23.19).
a
•
Install spacing washer (8) of calculated thick-
ness, and press on grooved ball bearing (9).
•
Check endplay of spring cluster (4).
L
Note:
Excessive endplay could be due to wear or incorrect
assembly.
Endplay:
Spring cluster
on shaft .................. 0.4...0.6 mm (0.016...0.024 in)
1
3
10
4
5
6
7
8
9
KR230081
23.13