Omconfig Rac Rmsnmptrap; Example Command; Omconfig Rac Rmuser - Dell Command Line Interface User Manual

omconfig rac rmsnmptrap

Use the omconfig rac rmsnmptrap command to remove an SNMP trap. Table 7-12 shows the valid
parameters for the command.
Table 7-12. omconfig rac rmsnmptrap
name=value pair
ipaddr=<text>
index=<n>

Example Command

The following example sets one name=value pair.
Type:
omconfig rac rmsnmptrap ipaddr=123.199.152.216
The following message appears:
Command Successful. Please reset RAC card!

omconfig rac rmuser

Use the omconfig rac rmuser command to remove a user. Table 7-13 shows the valid parameters for
the command.
Table 7-13. omconfig rac rmuser
name=value pair
username=<text>
index=<n>
Example Command
The following example sets one name=value pair.
Type:
omconfig rac rmuser username=jdoe
The following message appears:
Command Successful. Please reset RAC card!
Description
Specifies the IP address of entry which is to be deleted. This value
must be specified in dotted-decimal notation. If no IP address is
specified, an index must be specified.
Specifies the index of the entry which is to be deleted. If no index
is specified, an IP address must be specified.
Description
Specifies the user name of entry which is to be deleted. If no user name is
specified, an index must be specified.
Specifies the index of the entry which is to be deleted. If no index is
specified, a user name must be specified.
omconfig rac: Managing the Remote Access Controller
131