Installing The Palm Rest - Dell XFR D630 Service Manual

1 touch pad connector
14.2

Installing the Palm Rest

NOTICE: When reinstalling the palm rest, ensure that you reconnect the USB cable to the IO
dash board, and then reconnect the touch pad cable connector to the system board before
replacing the palm rest screws.
NOTE: If you are replacing the palm rest, remove the USB Control cable from the original palm
rest and route the same way in the new palm rest.
Underside of Palm Rest showing Touchpad Cable Route
Touchpad
cable
1. Install the 5 top-side screws.
2. Turn the system over.
3. Install the 11 bottom screws.
4. Reconnect the coin-cell battery (see
Page 80 of 106
TM
Dell XFR D630 Fully Rugged Notebook Service Manual
C oin-Cell Battery).
1 7 2 H
Touch pad
connector
Revision A01