Pc Card Reader - Dell XFR D630 Service Manual

NOTICE: To prevent intermittent contact between the ZIF-socket cam screw and the processor
when removing or replacing the processor, press to apply slight pressure to the center of the
processor while turning the cam screw.
2. Tighten the ZIF socket by turning the cam screw clockwise to secure the processor to the
system board.
NOTICE: If you are installing the original processor, skip to step 5. To install a new processor,
continue with step 3.
3. Clean the heat sink. Use the cleaning pad provided with the processor kit to remove any old
thermal grease between the 3 captive screws.
4. Apply the thermal grease. Follow the instructions provided with the processor kit, to use the
syringe to apply thermal grease in a spiral pattern to the processor thermal-cooling assembly.
5. Replace the processor thermal-cooling assembly (see
Cooling Assembly).
6. Replace the palm rest (see
NOTE: Ensure that you reconnect the coin-cell battery (see
the keyboard. I nstalling the Coin-Cell Battery
2 1 9 H
7. Replace the display assembly (see
8. Replace the keyboard (see
9. Replace the media bay device (see
10. Replace the hinge cover (see
11. Replace the battery.

19 PC Card Reader

CAUTION: Before working inside your computer, follow the safety instructions in the
XFR D630 Product Information Guide and in the XFR D630 User's Guide.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by
Page 90 of 106
TM
Dell XFR D630 Fully Rugged Notebook Service Manual
I nstalling the Palm Rest).
2 1 7 H
I nstalling the Display Assembly).
2 2 0 H
K eyboards).
2 2 1 H
X Bay Devices).
2 2 2 H
I nstalling the Hinge Cover).
2 2 3 H
I nstalling the Processor Thermal-
2 1 6 H
C oin-Cell Battery) before you replace
2 1 8 H
Revision A01