3. Attach the 2 antenna cables. Refer to the antenna cable wiring diagram to ensure the antenna
cables are properly attached.
4. Install the system board (see
25 Bottom Chassis
25.1
Removing the Bottom Chassis
CAUTION: Before working inside your computer, follow the safety instructions in the
XFR D630 Product Information Guide and in the XFR D630 User's Guide.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by
periodically touching an unpainted metal surface (such as a connector on the back of the
computer).
1. Follow the instructions in
2. Remove the system board (see
NOTE: When removing the system board you do not need to remove the system memory or the
processor.
3. Remove the fan (see
4. Remove the RF passthru board (see
5. Remove the modem cable (see
Page 104 of 106
TM
Dell
XFR D630 Fully Rugged Notebook Service Manual
I nstalling the System Board).
2 9 5 H
B efore You Begin.
2 9 6 H
R emoving the System Board).
2 9 7 H
R emoving the Fan).
2 9 8 H
R emoving the RF Passthru Board).
2 9 9 H
R emoving the Modem Cable).
3 0 0 H
Revision A01