Removing The Display Assembly - Dell XFR D630 Service Manual

10.1

Removing the Display Assembly

CAUTION: Before working inside your computer, follow the safety instructions in the
XFR D630 Product Information Guide and in the XFR D630 User's Guide.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by
periodically touching an unpainted metal surface (such as a connector on the back of the
computer).
1. Follow the instructions in
2. Remove the hinge cover (see
3. Remove the keyboard (see
NOTICE: To avoid damage to your computer, carefully reroute the cables in the appropriate
cable channels when replacing the display. Route the gray and black antenna cables beneath the
white antenna cable, and the black display cable on top of the white antenna cable.
NOTICE: For the optional Touch Screen Display, remove the touch controller cable from the I/O
board on the right side, near the right hinge.
4. Unplug the display cable:
a. Pull straight up on the pull-tab that is attached to the display-feed flex cable to
disconnect the cable from the system board.
NOTE: The following step is only for the optional Touch Screen display.
b. Disconnect the touch controller cable from the motherboard controller cable,
above the heat sink.
5. Disconnect the antenna cables from their card(s) (see
3
2
1
1 WLAN card
4 Display cable connector
Page 56 of 106
TM
Dell XFR D630 Fully Rugged Notebook Service Manual
B efore You Begin.
1 1 1 H
R emoving the Hinge Cover).
1 1 2 H
K eyboards).
1 1 3 H
2 antenna cable connectors
W LAN Card and R F Passthru Board).
1 1 4 H 1 1 5 H
3 RF Passthru cable connector
4
Revision A01