Table of Contents
Advertisement
Steps
After performing the pre-requisites, you are left with the palm-rest and keyboard assembly.
Installing the palm-rest and keyboard assembly
CAUTION:
The information in this section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
NOTE:
The system board can be installed with the heat sink attached to it in order to simplify the procedure and preserve
the thermal bond between the system board and heat sink.
The following image indicates the location of the palm-rest and keyboard assembly and provides a visual representation of the
installation procedure.
Figure 46. Installing the palm-rest and keyboard assembly
Steps
Place the palm-rest and keyboard assembly on a flat surface and perform the following steps to install the palm-rest and
keyboard assembly.
Next steps
1. Install the
system
board.
2. Install the
power-adapter
3. Install the
power button
88
Removing and installing Field Replaceable Units (FRUs)
port.
or the
power button with optional fingerprint
reader, whichever is applicable.
Advertisement
Table of Contents
