Hard Disk Drive Settings - NEC POWERMATE P60D Service Manual

Hard Disk Drive Settings

The following IDE hard disk drives are available for installation in the system. Systems
come with a hard disk drive pre-installed in the computer. Specifications for all the optional
IDE hard drives are given in Appendix B, Specifications. Jumpers for the drives are set for
single drive configurations. Jumper settings and their locations are shown in Figure Section
3-20.
One drive installed-
(Factory Setting)
Two drives installed-
Slave
Two drives installed-
Master
Cable Select
Configuration
(Dual Drives)
Figure Section 3-20 WDAC1270/2340/2420 270-, 340-, and 420-MB Hard Disk
NOTE: All NEC hard disk drives are shipped
with the jumpers set for: master, one drive
installed.
Power Connector
Signal Connector
Drives
Options 3-23
Front of Drive