Write To Cmos And Exit; Do Not Write To Cmos And Exit - NEC POWERMATE P60D Service Manual

2-16 Setup and Operation
To change or delete the password, do the following:
1. Highlight the "Change Password" selection on the Main Menu.
Press
2. Enter
or delete the password, as follows.
Change the password, by entering a new password, then follow steps 3, 4 and
5, above.
Delete the password, by pressing
appears.
3. Press Enter
If the password is forgotten, re-position the password jumper on the system board to
disabled (see "System Board Jumpers" later in this section).

Write to CMOS and Exit

This menu option opens a screen that saves the changes to CMOS and exit the Setup pro-
gram. Type y if save and exit the program or

Do Not Write to CMOS and Exit

This menu option opens a screen that exits the Setup program and without saving the
changes. Type if to exit the program and not save the changes, then press
y
to return to the program
An "Enter NEW Password" message appears on the screen. Change
.
to return to the Main Menu.
Enter . A "Password Now Disabled" message
y to exit without saving, then press Enter .
. Type
Enter n