Desktop Storage Device Installation - NEC PowerMate V486 Series Service Manual

One drive installed-
(Factory Setting)
Two drives installed-
Slave
Two drives installed-
Master
Cable Select
Configuration
(Dual Drives)
Figure Section 3-27 WDAC2540, 540-MB Hard Disk Drive
Figure Section 3-28 CFA850A, 850-MB Hard Disk Drive

DESKTOP STORAGE DEVICE INSTALLATION

Use the following procedure to install a storage device in the desktop system. The follow-
ing figure shows cable connector connections on the system board and power supply.
Power Connector
Signal Connector
NOTE: Do not remove the 5 1/4-inch blank
panel when installing a hard disk drive.
A 3 1/2-inch hard disk drive must be mounted in
a 5 1/4-inch bracket when installing it in a 5 1/4-
inch storage slot.
Options
Front of Drive
C/D
Drive 1 and Drive 2
Master (factory setting)
C/D
Drive 2 Slave
3-25