Disassembly And Reassembly - NEC POWERMATE P60D Service Manual

Section 6
Minitower Repair

DISASSEMBLY AND REASSEMBLY

This section contains step-by-step disassembly procedures for the minitower systems. The
hard disk drive, and 3 1/2-inch diskette drive are installed and included in these disassembly
procedures. Reassembly is the reverse of disassembly. Each procedure is supported by a
simplified disassembly illustration to facilitate removal. The detailed exploded-view diagram
and parts lists for the desktop systems are shown later in this section.
A Phillips-head screwdriver is the only required tool. For complete disassembly of the
system unit, follow the disassembly order listed in Table Section 6-1. To reassemble, follow
the table in reverse order.
Individual removal procedures do not require the total disassembly of the computer. Each
of the following subsections lists the parts that must be removed before beginning the
removal procedure. To reassemble, follow the procedure in reverse order.
Table Section 6-1 PowerMate P60 Minitower Disassembly Sequence
Sequence Part
1 Top cover
2 Bottom cover
3 Expansion board(s)
4 Front panel assembly
5 Power buttom cover
6 Blank panel and metel cover plate
7 Speaker assembly
8 SIMM memory
9 5 1/4-inch device cage
10 5 1/4-inch device
11 3 1/2-inch hard disk drive
12 3 1/2-inch diskette drive
13 Power supply
14 ISA/PCI-Bus backboard
15 System board
See Page
6-3
6-4
6-5
6-6
6-7
6-7
6-9
6-10
6-11
6-12
6-13
6-15
6-17
6-19
6-20