Table of Contents
Advertisement
System Board Configuration Settings
System board jumpers enable you to configure your system
for a particular system requirement.
You may need to change the system board settings to:
T
configure the system for a graphics board by disabling the
onboard VGA
T
restore the CMOS settings to their factory state
T
prepare the system for installation of a slower processor
T
configure the system to power on when the power cable is
plugged in instead of when the power button is pushed
Jumpers are set correctly at the factory for your
configuration.
If your system requires a jumper change, change
only the setting for that condition. Otherwise,
keep the jumpers at their factory settings.
The following figure shows jumper locations on the system
board.
! CAUTION
Configuring the System 3-35
Advertisement
Table of Contents
