Installing The Celeron Or Pentium Iii Upgrade Processor Cartridge - NEC POWERMATE ES 5200 Manual

7. Set the cartridge down on an antistatic surface or store it
in an antistatic bag.
Before picking up the processor cartridge, reduce
static discharge by touching the metal frame of
the system unit.
8. Install the upgrade processor (see "Installing the Celeron
or Pentium III Upgrade Processor Cartridge").
Installing the Celeron or Pentium III Upgrade Processor
Cartridge
Install the upgrade processor cartridge as follows.
Note:
out or write down your current CMOS Setup
parameters and store the information in a safe
place before installing a processor.
Note:
processor to a Celeron or Pentium II processor,
you must obtain a retaining bar to place over the
processor cartridge. See Chapter 7, "Getting
Services and Support," for information on
contacting NEC CSD for this part.
1. If you are replacing the processor cartridge currently in
your system, remove the cartridge (see "Removing the
Celeron or Pentium III Processor Cartridge").
! CAUTION
NEC CSD recommends that you print
If you are upgrading from a Pentium II
Installing Options 5-31