Table of Contents
Advertisement
Use the following procedure to use the latches correctly.
1. Make sure the chassis latches are in the open position.
2. Position the narrow ends of the system board rails in the
chassis guides.
3. Slide the system board partway into the system unit along
the chassis rail guides. Stop sliding the board when the
outside edge of the system board aligns with the outside
edge of the chassis (see the figures "Correct alignment of
the system board — small desktop" and "Incorrect
alignment of the system board — small desktop").
! CAUTION
To prevent damage to the latches, align the
system board with the outside edge of the
chassis before closing the latches.
4. Push the latches closed. This slides the board the rest of
the way into the system unit and secures it into the
connector on the riser board.
! CAUTION
If the board does not slide when you push the
latches, slide the board out of the unit a bit and
check the alignment position (see the figure
"Correct alignment of the system board — small
desktop"). Push the latches closed.
If the system board is aligned correctly, you might need
to push the outside edge of the board to fully seat it into
the riser board connector.
Installing Options 5-47
Advertisement
Table of Contents
