Table of Contents
Advertisement
4. Use the two handles on the board to carefully slide the
system board partway into the chassis, along the rail
guides.
Replacing the system board — minitower
A – System Board
B – Handles/Rails
5. Stop sliding the board when the edge of the system board
aligns with the hinged edge of the chassis floor.
6. Slowly close the chassis floor to slide the board into the
connector on the riser board.
If the board does not slide in when you attempt to
close the chassis floor, pull the board out of the
chassis a bit, check the alignment, and correct as
necessary. Close the chassis floor.
5-50 Installing Options
C – Rail Guides
! CAUTION
Advertisement
Table of Contents
